Post by 2001Trooper on Dec 25, 2004 15:35:30 GMT -5
Installed HID lighting system. Relay with system comes with 20amp fues and terminates to positive of battery. Headlight connectors connect to relay to send power to relay to engage new HID lights. I disconnected the battery while installing. Now: will not start (assuming no spark) , front wipers and fluid sprayer (inoperative) , fan motor for a/c (inoperative) , oil pressure guage maxes out during ignition starting position. I've check all fuses inside and out. I've reset door locks thinking I might have triggered theft prevention. I've put the original bulbs back and no luck. The inside terminals are +12v and center is ground with lights in low beam position. These polarities are reversed when high beam is engaged. The relay connector only use one outside terminal and the center. So it will receive only +12 for low and -12v for high beam selection. Any ideas before I have towed to Isuzu ? -thanks, Mark