Post by Frogger on Jan 24, 2004 22:59:52 GMT -5
Replaced head gasket, then engine quits after about 5 min. of operation. 2.6 L, 4cyl engine. Not 100% sure things were assembled correctly. (I had lots of help?) Fuel pump is working well, timing is correct, new plugs installed. O2 light is on, but that didn't stop it before. 150 lbs compression on all cyls. I'm probably missing something really easy, but don't know what it is. Any good ideas?? Thanks for any help...
P.S. After the computer controlled 5 minute warm up is when it quits. It will drive normally until hitting a stop light. Then it dies. After a re-start it drives normal again until the 5 min time is up again...then you can't slow to an idle without the engine dying again...the idle adjustment on the fuel injector doesn't seem to do anything either.
P.S. After the computer controlled 5 minute warm up is when it quits. It will drive normally until hitting a stop light. Then it dies. After a re-start it drives normal again until the 5 min time is up again...then you can't slow to an idle without the engine dying again...the idle adjustment on the fuel injector doesn't seem to do anything either.